360 Assembly/360 Instructions/ISK
ISK - Insert Storage Key - Opcode 09 - RR Instruction (360 Only) Privileged Instruction
Format
[edit | edit source]Opcode
[edit | edit source]| RR Instruction (2 bytes) | |||
| Byte 1 bits (0-7) |
Byte 2 | ||
|
target register (8-11) |
source register (12-15) | ||
| (in hex) | Opcode 09 |
(4 bits) 0..F / (dec 0..15) |
(4 bits) 0..F / (dec 0..15) |
- The first argument is a target register which value is affected by the instruction.
- The second argument is the source register.
- The target register and source register values are 0 to 15.
Example usage
[edit | edit source]- ISK R1,R2
Availability
[edit | edit source]The ISK instruction is available only on 360 models. It is a privileged instruction.
Purpose of Instruction
[edit | edit source]This instruction is used to get the Storage Key for the address specified in the Second operand and store into the first operand's bottom byte(1byte). ISK instruction provides support to get the storage key in 2K units of Page. ISKE will get the storage key for the 4K units of page.
Typical Usage
[edit | edit source]Operation
[edit | edit source]This is a privileged instruction, and is only available on the 360 series. The ISKE instruction is available on later 370 and zSystem processors.
Condition Codes
[edit | edit source]Condition codes are not changed.
Exceptions and Faults
[edit | edit source]- Privileged Operation
- Invalid Opcode (370 and z/System)
| Previous Instruction IPTE |
360 Assembly Instructions | Next Instruction ISKE |
| Previous Opcode 08 |
Next Opcode 0A |
 |
This page or section is an undeveloped draft or outline. You can help to develop the work, or you can ask for assistance in the project room. |