Jump to content

Embedded Systems/Serial and Parallel IO

From Wikibooks, open books for an open world

Data Transmission

[edit | edit source]

Data can be sent either serially, one bit after another through a single wire, or in parallel, multiple bits at a time, through several parallel wires. Most famously, these different paradigms are visible in the form of the common PC ports "serial port" and "parallel port". Early parallel transmission schemes often were much faster than serial schemes (more wires = more data faster), but the added cost and complexity of hardware (more wires, more complicated transmitters and receivers). Serial data transmission is much more common in new communication protocols due to a reduction in the I/O pin count, hence a reduction in cost. Common serial protocols include SPI, and I2C. Surprisingly, serial transmission methods can transmit at much higher clock rates per bit transmitted, thus tending to outweigh the primary advantage of parallel transmission. Parallel transmission protocols are now mainly reserved for applications like a CPU bus or between IC devices that are physically very close to each other, usually measured in just a few centimeters. Serial protocols are used for longer distance communication systems, ranging from shared external devices like a digital camera to global networks or even interplanetary communication for space probes, however some recent CPU bus architectures are even using serial methodologies as well.

Serial Transmission

[edit | edit source]

RS-232

[edit | edit source]

See Also

[edit | edit source]

RS-485

[edit | edit source]

See also

[edit | edit source]

I2C Inter-Integrated Circuit

[edit | edit source]

See Also

[edit | edit source]

I2C (Inter-Integrated Circuit) Bus Technical Overview and Frequently Asked Questions

Ethernet

[edit | edit source]

As on-chip memory increases, it is becoming more common to see Ethernet support in small system-on-chip embedded systems. New Ethernet ASIC products are also on the market. This allows an embedded system to have its own IP address on a network or on the internet. It can act as a server for its own webpage, to implement a GUI or general purpose I/O, and to display any relevant information such as sensor data, or even as a portal to remotely upgrade firmware. For example, many network routers have these features.

CANbus (Controller Area Network)

[edit | edit source]

See Also

[edit | edit source]

Firewire

[edit | edit source]

802.11/Wireless

[edit | edit source]

Serial ATA

[edit | edit source]

See Also

[edit | edit source]

Parallel Transmission

[edit | edit source]

Centronics

[edit | edit source]

Centronics is synonymous with the 1980's PC standard parallel printer interface.

PCI/PCI-X

[edit | edit source]
[edit | edit source]

For further reading

[edit | edit source]


This page of the Embedded Systems book is a stub. You can help by expanding this section.