LMIs in Control/pages/Minimum Decay Rate in State Feedback
LMIs in Control/pages/Minimum Decay Rate in State Feedback
The System:
[edit | edit source]The number of LMI constraints needed to check quadratic stability is reduced if all the subsystems in the polytopic model has the same matrix . This can be achieved by adding an Apkarian filter in the input of the system.
The Optimization Problem:
[edit | edit source]Apkarian Filter
Let consider our TS-LIA model. This can be re written in linear form as:
The filter should be such that the equilibrium of the states are the input values and the dynamics should be fast, so we could assume the dynamics of the filter negligible (i.e. the input of the filter is equivalent to the input of the quadrotor). One possible filter is shown , where = −100, = 100 and ∈ is the identity matrix.
- .
When applying the filter, we are imposing that the output of the filter is the new input of the TS-LIA model (i.e. = ). Then, the extended model is:
This prefiltering does not affect the procedure followed to obtain the TS-LIA model, so the premise variables, membership functions and activations functions remains the same.
State Feedback Controller Design
Let consider the state feedback control law for the extended TS-LIA model:, where the state feedback control laws are :, we get the closed loop system :
The LMI:
[edit | edit source]The design of the controller is done by solving an LMI problem involving the quadratic stability constraints. In case we want D- stabilization, the following set of LMI constraints are needed:
- ∀i = 1, . . . , 32.
A pair of conjugate complex poles s of the closed loop system can be written as = − where is the damping ratio, is the undamped natural frequency and is the frequency response defined as .Three different LMI regions have been considered, each one related with a performance specification regarding and :
Minimum Decay Rate:
If we want to set a minimum decay rate α in the closed loop system response, the poles should be inside the LMI region defined in : = [s = x + j y | x < − ].where > 0. In this case L = and M = 1.
Applying condition to the closed-loop system , the LMI condition associated to this LMI region is:
- ∀i = 1, . . . , 32.
Conclusion:
[edit | edit source]The LMI is feasible.
Related LMIs
[edit | edit source]- Apkarian Filter and State Feedback. https://en.wikibooks.org/wiki/LMIs_in_Control/pages/Apkarian_Filter-and_State_Feedback
- Maximum Natural Frequency in State Feedback https://en.wikibooks.org/wiki/LMIs_in_Control/pages/Maximum_Natural_Frequency_in_State_Feedback#The_LMI%3A
References
[edit | edit source]- Control, A. (2016). Gain-scheduling Control of a Quadrotor Using the Takagi-Sugeno Approach.