Waves/Superposition

Waves : 1 Dimensional Waves
1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13
Examples - Problems - Solutions - Terminology

Superposition Principle

It is found empirically that as long as the amplitudes of waves in most media are small, two waves in the same physical location don't interact with each other. Thus, for example, two waves moving in the opposite direction simply pass through each other without their shapes or amplitudes being changed. When superimposed, the total wave displacement is just the sum of the displacements of the individual waves. This is called the superposition principle. At sufficiently large amplitude the superposition principle often breaks down -- interacting waves may scatter off of each other, lose amplitude, or change their form.

Interference is a consequence of the superposition principle. When two or more waves are superimposed, the net wave displacement is just the algebraic sum of the displacements of the individual waves. Since these displacements can be positive or negative, the net displacement can either be greater or less than the individual wave displacements. The former case is called constructive interference, while the latter is called destructive interference.

Figure 1.5: Superposition (lower panel) of two sine waves (shown individually in the upper panel) with equal amplitudes and wavenumbers $k_{1}=4$ and $k_{2}=5$

Let us see what happens when we superimpose two sine waves with different wavenumbers. Figure 1.5 shows the superposition of two waves with wavenumbers $k_{1}=4$ and $k_{2}=5$. Notice that the result is a wave with about the same wavelength as the two initial waves, but which varies in amplitude depending on whether the two sine waves are in or out of phase. When the waves are in phase, constructive interference is occurring, while destructive interference occurs where the waves are out of phase.

Figure 1.6: Superposition of two sine waves
Figure 1.6: Superposition of two sine waves with equal amplitudes and wavenumbers $k_{1}=10$ and $k_{2}=11$

What happens when the wavenumbers of the two sine waves are changed? Figure 1.6 shows the result when $k_{1}=10$ and $k_{2}=11$. Notice that though the wavelength of the resultant wave is decreased, the locations where the amplitude is maximum have the same separation in $x$ as in figure 1.5.

Figure 1.7: Superposition of two sine waves with equal amplitudes and wavenumbers $k_{1}=10$ and $k_{2}=12$.

If we superimpose waves with $k_{1}=10$ and $k_{2}=12$, as is shown in figure 1.7, we see that the $x$ spacing of the regions of maximum amplitude has decreased by a factor of two. Thus, while the wavenumber of the resultant wave seems to be related to something like the average of the wavenumbers of the component waves, the spacing between regions of maximum wave amplitude appears to go inversely with the difference of the wavenumbers of the component waves. In other words, if $k_{1}$ and $k_{2}$ are close together, the amplitude maxima are far apart and vice versa.

Figure 1.8: Representation of the wavenumbers and amplitudes of two superimposed sine waves.

We can symbolically represent the sine waves that make up figures 1.5, 1.6, and 1.7 by a plot such as that shown in figure 1.8. The amplitudes and wavenumbers of each of the sine waves are indicated by vertical lines in this figure.

The regions of large wave amplitude are called wave packets. Wave packets will play a central role in what is to follow, so it is important that we acquire a good understanding of them. The wave packets produced by only two sine waves are not well separated along the $x$-axis. However, if we superimpose many waves, we can produce an isolated wave packet. For example, figure 1.9 shows the results of superimposing $20$ sine waves with wavenumbers $k=0.4m$, $m=1,2,\ldots ,20$, where the amplitudes of the waves are largest for wavenumbers near $k=4$.

Figure 1.9: Superposition of twenty sine waves with $k_{0}=4$ and $\Delta k=1$.

In particular, we assume that the amplitude of each sine wave is proportional to $\exp[-(k-k_{0})^{2}/\Delta k^{2}]$, where $k_{0}=4$ and $\Delta k=1$. The amplitudes of each of the sine waves making up the wave packet in figure 1.9 are shown schematically in figure 1.10.

Figure 1.10: Representation of the wavenumbers and amplitudes of 20 superimposed sine waves with $k_{0}=4$ and $\Delta k=1$.

The quantity $\Delta k$ controls the distribution of the sine waves being superimposed -- only those waves with a wavenumber $k$ within approximately $\Delta k$ of the central wavenumber $k_{0}$ of the wave packet, i. e., for $3\leq k\leq 5$ in this case, contribute significantly to the sum. If $\Delta k$ is changed to $2$, so that wavenumbers in the range $2\leq k\leq 6$ contribute significantly, the wavepacket becomes narrower, as is shown in figures 1.11 and 1.12.

Figure 1.11: Superposition of twenty sine waves with $k_{0}=4$ and $\Delta k=2$.

Figure 1.12: Representation of the wavenumbers and amplitudes of 20 superimposed sine waves with $k_{0}=4$ and $\Delta k=2$.

$\Delta k$ is called the wavenumber spread of the wave packet, and it evidently plays a role similar to the difference in wavenumbers in the superposition of two sine waves -- the larger the wavenumber spread, the smaller the physical size of the wave packet. Furthermore, the wavenumber of the oscillations within the wave packet is given approximately by the central wavenumber.

We can better understand how wave packets work by mathematically analyzing the simple case of the superposition of two sine waves. Let us define $k_{0}=(k_{1}+k_{2})/2$ where $k_{1}$ and $k_{2}$ are the wavenumbers of the component waves. Furthermore let us set $\Delta k=(k_{2}-k_{1})/2$. The quantities $k_{0}$ and $\Delta k$ are graphically illustrated in figure 1.8. We can write $k_{1}=k_{0}-\Delta k$ and $k_{2}=k_{0}+\Delta k$ and use the trigonometric identity $\sin(a+b)=\sin(a)\cos(b)+\cos(a)\sin(b)$ to find $\sin(k_{1}x)+\sin(k_{2}x)=\sin[(k_{0}-\Delta k)x]+\sin[(k_{0}+\Delta k)x]$ $=\sin(k_{0}x)\cos(\Delta kx)-\cos(k_{0}x)\sin(\Delta kx)+$ $\sin(k_{0}x)\cos(\Delta kx)+\cos(k_{0}x)\sin(\Delta kx)=2\sin(k_{0}x)\cos(\Delta kx).$ (2.17)

The sine factor on the bottom line of the above equation produces the oscillations within the wave packet, and as speculated earlier, this oscillation has a wavenumber $k_{0}$ equal to the average of the wavenumbers of the component waves. The cosine factor modulates this wave with a spacing between regions of maximum amplitude of

$\Delta x=\pi /\Delta k.$ (2.18)

Thus, as we observed in the earlier examples, the length of the wave packet $\Delta x$ is inversely related to the spread of the wavenumbers $\Delta k$ (which in this case is just the difference between the two wavenumbers) of the component waves. This relationship is central to the uncertainty principle of quantum mechanics.

---

Waves : 1 Dimensional Waves
1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13
Examples - Problems - Solutions - Terminology